BARTEMP-BŪ (BAINITE)

Furnished in pre-hardened condition, this material is tougher than BARTEMP-M (MARTENSITE), allowing the fabrication of parts where various shaping technologies, such as blanking, bending, drawing, stretching, extrusion, coining, or swaging might be involved. Because the material is already hardened, the following benefits can be realized:
   a) Additional steps to correct distortion inherent in part hardening are eliminated.
   b) Closer dimensional tolerances and improved finish.
   c) Parts require no further heat treatment, saving on labor, utility costs and capital equipment.
   d) Lead times can be shortened.

This material is available in the following grades:
    TRM-14 (AISI-1050), TRM-26 (AISI-1065),
    TRM-34 (AISI-1074), TRM-54 (AISI-1095).
    TRM = Theis Raw Material

BARTEMP-B, made out of TRM-14 and TRM-26, can undergo considerable shaping. However, BARTEMP-B, made out of TRM-34 and TRM-54, is suitable for lightly shaped components. For applications where good wear resistance is needed mostly along the edges of the material, it is recommended that higher grade BARTEMP-B be used.

SIZE RANGES OF BAINITE:
TRM-14: 0.015-0.080" (.38-2.0 mm)
TRM-34: 0.015-0.080" (.38-2.0 mm)
TRM-26: 0.025-0.080" (.64-2.0 mm)
TRM-54: 0.025-0.080" (.64-2.0 mm)
Other sizes available upon request. TRM = Theis Raw Material


BARTEMP-BŪ
  Minimum Bend Radius
    Thickness   U.T.S. %  |  Rolling Direction  =
AISI TRM # in. mm. RC KSI Elong in. mm. in. mm.
1050 14 .020 (.51) 44 210 7 .040 (1.02) .080 (2.03)
1065 26 .028 (.71) 43 200 6 .060 (1.52) .095 (2.41)
1074 34 .040 (1.02) 41 190 6 .080 (2.03) .100 (2.54)
  34 .040 (1.02) 48 225 5.5 .125 (3.17) .170 (4.32)
1095 54 .042 (1.07) 41 195 8.5 .090 (2.20) .110 (2.79)


Back to Contents